![]() Taking care to align the grip with the club face using the center line as a guide. Push the grip over the tape onto the shaft.Be sure to do this over a container to catch the spirits Pour the excess mineral spirits from the grip over the tape on the putter shaft. Pour out the excess mineral oils from the grip.Hold a finger over the air hole and the base of the grip and shake well to distribute the mineral spirits. Generously apply mineral spirits over the tape and inside the grip. Coat the interior of the new grip with Mineral Spirits. ![]() Tuck the tape hanging over into the shaft. 580 in diameter, additional build-up of masking tape is suggested at this point.Īpply approximately 11.5 inches of double-side grip tape to the shaft, leaving approximately a 1/2” overhang at the top of the shaft. This will determin if you need to put extra wraps of tape under the grip Measure the butt end of the shaft with a measuring device. ![]() This will remove the glue and tackiness left behind by the grip tape Clean shaft to remove existing grip tape.Use a utility knife to remove the existing grip ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |